The Hep₂O flexible push-fit piping system for hot and cold water is simplicity itself. Cut Hep₂O to length, insert a support sleeve, push the pipe home into its Hep₂O fitting - and that's all.

Kitemarked to BS7291 parts 1 & 2, class S, Hep₂O is equally easy to fit, extend, alter or dismantle. Hep₂O joints don't leak, even when rotated under pressure.

Hep₂O flexible pipe is fully compatible with copper pipework and compression fittings. But unlike copper, Hep₂O cannot cause electrolysis problems in steel hulls. Chemically inert, non-toxic and resistant to growth of algae, Hep₂O imparts no taste to the water.

Face the winter with confidence with Hep₂O pipework, frost proof to -10ºC (14ºF)... but don't forget to drain the system, all the same!

Choosing the right pipe size

Use Hep₂O 15mm pipe and fittings throughout for small marine pressurised water systems.

Hep₂O 22mm or 28mm pipe is recommended for main water lines in larger systems. Cleghorn Waring's technical department will advise you on pipe size.

• Advanced BiTite Fittings
• Smartpack pipe dispenser straight.... from the coil

• Low heat loss - water stays hotter longer in pipes
• Pressure rated to:
  12 bar (175psi) at 20ºC (68ºF)
  3 bar (44psi) at 82ºC (180ºF)
• Hold in place with single screw Hep₂O pipe clips
• Low noise transmission
• Ideal for pressurised hot and cold water and marine central heating
• Easily bent by hand to minimum radius 8 x pipe diameter